Product Description

Safety
Travelling. Variable travelling speed for precise positioning of loads.
Wire rope. In galvanized steel as a standard, high safety factor (factor 4.6 – FEM 2m).
Electrical cubicle. The cover can be folded back so that you can store your tools for maintenance (the cover has two steel safety wires to prevent it from falling).
MT2. Electronic control of the recording of hoist solicitation status.
Electrical. Low voltage control for more safety.
Traverse wheels. The 4 steering wheels are fully streamline for improved safety.
Hook and Pulley Block. Rotating hook and pulley block with safety latch.

Easy maintenance
Hoisting motor. Motor cooling increased by 30% (tunnel effect)
Hoisting brake. The brake is tested for hoist longevity under normal use conditions.
Steering motor-reducer. Steering reducer with one rail and a permanently lubricated connection.
Drum. The drum has been completely covered for better protection.
Rope guide. Built [without spring" so that it can be more easily replaced during maintenance.
Electrical cubicle. The wires go in and out by means of steel plugs that can be unbound and that are built into the case.
MT2. Calculation of the SWP
Assembly is modules, for easier management of spare parts for replacement
Surface treatment. 2-component epoxy paint with 120μ for greater protection.

Ergonomics
Hook and pulley block. Ergonomical hook (area to grab and hold).
Push button box. Made with tinted polypropylene, grounded, with double insulation, ergonomical (IP 65 protection). Optional load display available
Electrical cubicle. Located on the side of the hoist, easily accessible. The open / close system used a quick closure method.

Savings
Hoisting motor. 60% operating factor and tropicalised as a standard for greater longevity.
Travelling motor. Tropicalised as a standard for greater longevity.
Pulley block. The best dimension on the market for optimal use of the size of your buildings and optimal use of work areas
Travelling. Variable travelling speed to reduce wear on steering rollers
Load limiter. As ordered by the directive on [Machines" (required equipment). All EUROCRANE VTs are equipped with a load limiter as a standard (safety measure in the event of hoist overload). For greater longevity
Hook and pulley block. Doesn`t take up much space, permanently lubricated rollers, pulleys are in GGG cast iron, very resistant. A high pulley / wire rope diameter ratio gives the wire rope greater longevity.

High technology
Pulley block. Only a small shift of the pulley block for hoisting (lifting is almost perfectly centred).
Rope guide. The guidance system does not get dirty, which allows for use in any type of environment.
Drum. A very high wire rope / drum diameter ratio (twice as large as the standard one), which:
Increases the longevity of the wire rope.
Reduces the approach data of the hoist
Reduces the [C" approach data of the hook
Electrical case. Quite large, it is equipped with the speed variation module as a standard
Lifting gearbox. Direct impulse gearbox unit, helicoid toothed gears, permanently lubricated, detector to prevent pressure overload.
Optimal positioning of steering rollers. The 4 steering rollers equally share the load in order to optimise your tracks

OPTIONS
In addition to standard equipment each EUROBLOC VT can be fitted with mechanical or electrical optional features in order to satisfy your specific requirements:
Variable hoisting speed / Second brake / Anti-collision device /Optical and audible warning connected to overload limit switch /Auxiliary hoist / Double hoist / Special crab / Rain cover / more at inquiry --

Contact us if you need more details on Wire Rope Hoist 5t. We are ready to answer your questions on packaging, logistics, certification or any other aspects about 5t Wire Rope Hoist、Beautiful-painted Wire Rope Hoist. If these products fail to match your need, please contact us and we would like to provide relevant information.

Product Categories : Hoist > Electric Wire Rope Hoist